液壓升降機在不同時段的保養細節是不一樣的，液壓升降機小編帶您詳細的了解一下。

The maintenance details of the hydraulic elevator are different in different periods. The small braid of the hydraulic elevator will let you know in detail.

一、日常保養

1、 Daily maintenance

升降機在保養時，如果需要人員進入到平臺內部，一定要吊住升降機或撐起維修支撐，防止升降機突然下降而造成人員傷亡。

During the maintenance of the elevator, if people need to enter the platform, be sure to hang the elevator or support the maintenance support to prevent casualties caused by the sudden drop of the elevator.

1.注意檢查滾輪、中間軸及軸承；油缸銷軸及軸承；臂架銷軸及軸承等部件的潤滑度和磨損情況；

1. Check the roller, intermediate shaft and bearing; Oil cylinder pin shaft and bearing; Lubrication and wear of boom pin shaft, bearing and other components;

2.對上述各部件加注潤滑油。延長軸承的使用壽命；

2. Fill the above components with lubricating oil. Prolong the service life of the bearing;

3.注意檢查液壓油的油質和油位。升降機升高時液壓油面應高于油箱底部40-50mm。當液壓油出現以下狀況：油色變暗、油質發粘，或油中有砂礫等異物時，一定要及時更換液壓油。一般的升降機的液壓系統采用的都是32#液壓油；

3. Check the oil quality and oil level of hydraulic oil. The hydraulic oil level shall be 40-50mm higher than the bottom of the oil tank when the elevator rises to high. When the hydraulic oil has the following conditions: the oil color becomes dark, the oil is sticky, or there are foreign matters such as gravel in the oil, the hydraulic oil must be replaced in time. The hydraulic system of general elevator adopts 32# hydraulic oil;

二、半年維護保養

2、 Half year maintenance

1.注意檢查液壓管道和接頭。油管不得破損，接頭不得松動；

1. Pay attention to check the hydraulic pipes and joints. The oil pipe shall not be damaged and the joint shall not be loose;

2.注意檢查回油節流閥。在拆卸下回油節流閥后，要用壓縮空氣將柱塞吹凈、用油洗凈后，再重新安裝。

2. Check the oil return throttle valve. After removing the oil return throttle valve, blow the plunger with compressed air and wash it with oil before reinstalling it.

三、年終保養

3、 Year end maintenance

1.注意檢查液壓和管道的連接部位。如果發現管道有破損應立即更換；連接部位有松動時應注意擰緊管接頭；

1. Pay attention to check the connecting parts of hydraulic and pipeline. If the pipeline is found damaged, it shall be replaced immediately; When the connecting part is loose, pay attention to tightening the pipe joint;

2.卸下并拆開下降閥進行檢查，用壓縮空氣將閥芯吹凈后重新裝上；

2. Remove and disassemble the lowering valve for inspection, and reinstall it after blowing the valve core with compressed air;

3.把油箱中的液壓油全部放凈后打開油箱，取出內部的吸油過濾器進行清洗，洗凈后放回油箱，按照原位進行安裝，油箱中重新注滿新的液壓油即可。

3. After all the hydraulic oil in the oil tank is drained, open the oil tank, take out the internal oil suction filter for cleaning, put it back into the oil tank after cleaning, install it in situ, and refill the oil tank with new hydraulic oil.

以上就是為大家介紹的有關電動液壓貨梯的詳細介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務

The above is a detailed introduction to the electro-hydraulic cargo elevator. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service